After three thousand layers, I wasn’t able to get the part to keep printing. I was printing this part at 50µm and after the second set of layers, the part ended up going up to a random Z height that wasn’t on an even .00 number so I wasn’t able after several attempts to resume the part (e.g. start at again at layer 3001 or .05*3001 = 150.05 but I can only from the Kudo3D gui set the linear stage to 150.0 or 150.01). I was assuming that to restart that one layer of 50µm wouldn’t matter and attachment would still happen but it didn’t. Also note that I tried the first time with the same exposure settings and slower lift speed. Seccond attempt, I added .5 sec of exposure. Aaargh.
↧