I can’t start a new topic (being logged auto logged out right now?).
After flipping the vat plate around and reinstalling everything I was finally ready to start working with my printer. However I can’t get the Linear stage to move through the Kudo Software.
When everything is plugged in the controller board flashes green for a while. Then when I launch the Kudo software the green light is gone but the software states a connection is made. According to the manual, I should be able to now press up or down 1-10mm on the software controller and have the linear stage move up or down. When I enable Z-calibration, still I’m not getting any reponse from software up or down on the linear stage! Very frustrated at the moment.
Attached is what I’m getting from Kudo Software. Can anyone confirm that the green light on the controller board normally behaves this way? Am I missing something?
Thank you,
Jason
